Download and install - update Galaxy S PLUS I9001 with ICS Nexus Styled Custom My Simple ROM Firmware

 

How to Update Galaxy S PLUS I9001 with ICS Nexus Styled Custom ROM Firmware

Procedure to Update Galaxy S PLUS I9001 with My Simple ROM Firmware:

• Download My Simple Custom ROM firmware Package in your computer. Once downloaded, connect your Galaxy S PLUS I9001 from here to your computer and place the downloaded zip file in your phone, Ensure that you are not placing the zip file deep into the sub folders.

• Disconnect the device and turn off the device so that it can be then entered in the recovery mode.

• Recovery mode in Galaxy S PLUS I9001 can be entered by holding the Volume Up button + the Home key button (the middle button). While holding these both buttons, turn ON your device. In recovery mode, select “Wipe data/factory reset” & “Wipe Cache partition”. Additionally, select “advanced” and clear the Dalvik cache too if you are on the custom ROM firmware.

• Select “install zip from sd card” > “choose zip from internal sd card” and then choose the My Simple Custom ROM firmware Package which you placed in your device. Once you have selected the file, it will take around 3 – 4 minutes for applying the same. Also, it will take more time than usual for rebooting the device in the normal mode. Don’t press the power button or reinsert the battery at this point of time

Note: If the device gets into the boot loop sequence or say gets stuck in the welcome screen, just re insert the battery and re follow the above instructions so as to again follow the above mentioned instructions.

So congratulations you have successfully applied the update of My Simple Custom ROM firmware in your Galaxy S PLUS I9001. You can check the same from the path “Settings > About Phone” to check whether it has been updated or not. Do share with us in the comments section just in case if you face any issues and we will try out level best to sort out the same.